Influence of surface passivation on optical properties of spray pyrolysis deposited Pd-F:SnO2
Loading...
Date
2014-09-10
Authors
Munji, M. K.
Mwathe, P.M.
Musembi, R. J.
Odari, B.V.
Munguti, Lawrence
Ntilakigwa, Alex Alfred
Nguu, John
Aduda, Bernard
Muthoka, Boniface
Journal Title
Journal ISSN
Volume Title
Publisher
Science Publishing Group
Abstract
Pd-F:SnO2 thin films have been prepared by spray pyrolysis technique using an alcoholic precursor solution consisting of stannic chloride (SnCl4.5H20), ammonium fluoride (NH4F) and palladium chloride (PdCl2). Optimization on the deposition parameters has been done in order to obtain high quality thin films. The effect of varying the fluorine content on the optical properties of Pd-F:SnO2 thin films were studied. Data for transmittance and reflectance in the wavelength range from 300nm – 2500nm was measured using the solid spec 3700DUV spectrophotometer. The calculated optical band gap of
the as prepared thin films has been found to range from 3.8eV to 4.11eV. Fluorine incorporation for Pd-F:SnO2 has been found to have a narrowing effect on the band gap, but at its higher concentration the band gap has been seen to increase. The band gap narrowing is due to the incorporation of F- ions in the crystal lattice therefore giving rise to donor levels in the SnO2 band gap which is an essential characteristic for the gas sensor applications. Both annealing and passivation have been found
to have very insignificant change in optical band gap of Pd-F:SnO2
Description
doi: 10.11648/j.ijmsa.20140305.11
Keywords
Spray Pyrolysis, Fluorine Doping, Palladium Doping, Co-Doping, Palladium and Fluorine Co-Doping, Annealing, Passivation, Pd and F Co-Doped SnO2 (Pd-F:SnO2)
Citation
International Journal of Materials Science and Applications 2014; 3(5): 137-142 Published online September 10, 2014 (http://www.sciencepublishinggroup.com/j/ijmsa) doi: 10.11648/j.ijmsa.20140305.11