Characterization of TiO2 based dye-sensitized Solar Cell prepared by screen printing method
Loading...
Date
2014
Authors
Munji, M. K.
Muendo, Musila Nicholas
Simiyu, J.
Journal Title
Journal ISSN
Volume Title
Publisher
Abstract
The dye-sensitized solar cells can provide an economically credible alternative in mitigating the
challenges presented by the current convectional photovoltaic devices. Whereas the semiconductor
assume both the task of light absorption and charge carrier transport, the two functions are separated.
Light is absorbed by a sensitizer which is anchored 10 the surface of a wide band semiconductor. Charge
separation takes place at the interface via photo-induced electron injection from the dye into the
conduction band of the semiconductor. Carriers are transported in the conduction band of the
semiconductor to the charge collector. The use of sensitizers in conjunction with oxide filrns of nano crystalline
morphology provides a broad absorption band and permits to harvest a large fraction of
sunlight. Nearly quantitative conversion of incident photon into electric current is achieved over a large
spectral range extending from the UV to the near IR region. Overall solar energy to electrical energy
conversion efficiencies of over 10% has been reported ln addition, there are good prospects to produce
these cells at lower cost than conventional solar cells This research aims at contributing to the foregoing
research on characterization of low cost Ti02 based dye sensitized solar cells. To achieve that, black berry
dye was used as the electron donating species. Blackberry dye was extracted from blackberry fruit and
adsorbed onto a nano-porous titania substrate. The nano-porous Ti02 was prepared by sol-gel process and
its layer \NaS mounted on a glass substrate by employing screen printing technique. Using DUV3700
spectrophotometer, the Ti02 layer was characterized \0 obtain its optical properties which are
transmittance and reflectance. Graphite coated glass 1\3S used as the counter electrode. An UIo•
electrolyte solution was used as the redox couple. This solution was made of potassium iodide saturated
with iodine. The solar cell parameters were determined 85 3 way of characterizing the solar cell. They
included open circuit voltage (Voc), short circuit current (l sc ). fill factor (FF), power at maximum power
point (Prnax) of the solar cell and efficiency (11).
Description
Keywords
Dye-Sensitized, Amorphous Silicon, Cornplementariry, Outdoor Performance
Citation
1st Young Scientists' MSSEESA Conference on Materials Science and Solar Cell Technology Abstract No 26