CW-Department of Physics

Permanent URI for this collection

https://repository.ku.ac.ke/handle/123456789/4365

Browse

Browsing CW-Department of Physics by Author "Okullo, W."

Now showing 1 - 2 of 2
  • Thumbnail Image
    Item
    Application of LBIC measurements for characterisation of triple junction solar cells
    (Elsevier, 2014-04-15) Munji, M. K.; van Dyk, E.E.; Kwarikunda, N.; Vorstera, F.J.; Okullo, W.
    In this study the Light Beam Induced Current (LBIC) imaging technique was used to characterise InGaP/InGaAs/Ge triple junction solar cells. The study focused on the use of monochromatic and solar light as beam probes to obtain photocurrent response maps from which the presence of any current reducing features on the solar cell were identified. Point illuminated current voltage (I–V) curves were obtained simultaneously while LBIC scanning measurements were being made. Curve fitting using an interval division algorithm based on the single diode model was performed to extract basic point device and performance parameters to give a rough indication of the functioning of the triple junction device. Using red and blue lasers as beam probes, reverse voltage breakdown was observed on the I–V curves which could be attributed to the Ge bottom subcell not being fully activated. The extracted parameters obtained when using monochromatic and solar light beam probes showed a large variation, indicating the dependence of I–V parameters on the spectral content of the beam probe.
  • Thumbnail Image
    Item
    Characterization of a low concentrator photovoltaics module
    (Elsevier, 2012-05) Munji, M. K.; Butler, B.A.; van Dyk, E.E.; Okullo, W.; Booysen, P.
    Low concentration photovoltaic (LCPV) systems have the potential to reduce the cost per kWh of electricity compared to conventional flat-plate photovoltaics (PV) by up to 50%. The cost-savings are realised by replacing expensive PV cells with relatively cheaper optical components to concentrate incident solar irradiance onto a receiver and by tracking the sun along either 1 axis or 2 axes. A LCPV module consists of three interrelated subsystems, viz., the optical, electrical and the thermal subsystems, which must be considered for optimal module design and performance. Successful integration of these subsystems requires the balancing of cost, performance and reliability. In this study LCPV experimental prototype modules were designed, built and evaluated with respect to optimisation of the three subsystems and overall performance. This paper reports on the optical and electrical evaluation of a prototype LCPV module.